Tandberg Data Magnum 224 Product Manual page 262

A E—E M
PPENDIX RROR ESSAGES
Table E-1 Library error messages (continued)
Error Message
No Empty Drive
No Empty I/E Port
No Enabled I/E Port
No Medium Removal
No USB Device
Not Calibrated
Not Implemented
Operation Aborted
Operation Stopped
Operator Action
Over Temperature
P M
RODUCT ANUAL
244
Description
The requested move cannot
be completed because there
is no empty tape drive to act
as the destination for the
move.
The requested move cannot
be completed because there
is no empty I/E port to act as
the destination for the move.
The requested command
cannot be completed
because there is no enabled
I/E port.
Media removal from the
library has been prevented
through the backup
application.
The library does not see a
USB device.
The manufacturing
calibration of the library is
not complete or has been
compromised.
The command is not
implemented in this library.
The current operation was
aborted by the host or user.
The current operation was
stopped by the host or user.
You are required to
intervene.
The tape drive's
temperature limit has been
exceeded, and the cartridge
has been ejected from the
tape drive.
Corrective Action
ƒ Use either SCSI or front panel commands to
empty a tape drive and retry the command.
ƒ Select a different type of element as the
destination.
ƒ Use either SCSI or front panel commands to
empty an I/E Port and retry the command.
ƒ Select a different type of element as the
destination.
ƒ Enable an I/E port and retry the command.
-or-
ƒ Select another command.
ƒ Turn off media removal prevention from the
backup application and retry the operation.
ƒ Reset the library and retry the operation.
ƒ Ensure that the USB device is securely inserted
and retry.
ƒ Try another USB device.
Contact Technical Support or your service
provider.
No corrective action
Retry the operation, if desired.
Retry the operation, if desired.
Operator intervention required:
ƒ New tapes needed
ƒ Correct error (see other errors in this table)
ƒ Wait until the library has cooled, and then
unload the cartridge to a cell and re-load it into
the tape drive.
ƒ Check the room temperature. The ambient
temperature must be no more than 40°C
(104°F).
ƒ Provide additional air flow around the library to
improve cooling.
1017472