Tandberg Data Magnum 224 Product Manual page 108

C 4—U R
HAPTER SING THE EMOTE


Type: Number This indicates the type of the address (I/E port, slot, or tape
drive).
Status This indicates the status (POVA) of the address, as follows:
Label Valid Indicates whether the bar code label information for the element
is considered valid (1) or questionable (0). The bar code label information is
considered questionable if the library had a problem reading the label.
Label If the element contains a cartridge, this field provides the bar code
label information for the cartridge. If the cartridge does not contain a bar code
label, it shows the cell number (the same as the address).
This field also indicates the type of data cartridge (L1=LTO1, L2=LTO2,
L3=LTO3, and L4=LTO4).
compatibility.
P M
RODUCT ANUAL
90
M U
ANAGEMENT TILITY
Slots–Addresses 1 through 24 represent magazine slots for the Magnum 224
and StorageLibrary T24.
Addresses 1 through 20 for the StorageLoader 2U LTO.

The slot numbers begin with the right magazine and continue with the
left magazine.

The storage cells decrease or increase based on the I/E Port setting
(enabled or disabled). Disabling the I/E Port increases the storage cell
count. See "Enabling and Disabling the I/E Port" on page
Tape Drives–The addresses for the tape drives are defined as follows:
Tape drive style
Single full height
Second half height
Single half height
Letter or Number
"P"
"O"
"V"
"A"
1
0
Location Element Address
Default
Top
Bottom
Definition
Slot Present
Slot Occupied
Slot Occupied and Valid
Slot Accessible
Yes
No
Table 5-1 on page 115 provides data cartridge
45.
81
82
81
1017472