Tandberg Data Magnum 224 Product Manual page 77

6. 6. 6. 6.
7. 7. 7. 7.
S
The Autoclean option enables the library to automatically perform tape drive
cleaning without operator intervention. When Autoclean is enabled, the
library monitors the cleaning requirements of the tape drive(s). When a tape
drive indicates it needs cleaning, the library loads the cleaning cartridge into
the tape drive. After the cleaning cycle is complete, the tape drive unloads and
ejects the cleaning cartridge, and the library resumes operation.
! ! ! !
Note:
Setting up automatic tape drive cleaning involves two procedures:


A 2007
UGUST
Press OK.
Press Back (as needed) to return to the Home screen.
The Home screen now indicates that the library is operating in Sequential
Mode by the following changes.
TANDBERG DATA
Seq : Idle
A-2 : No Tape
A-1 : No Tape
Move

Lib (Library) is replaced with Seq (Sequential).

D-1 (Drive-1) and D-2 (Drive-2) are replaced with A-1 and A-2
(indicating autoload function).
U A
ETTING P UTOMATIC
If you plan to use automatic cleaning, the cleaning cartridge
Important
should be stored in:
ƒ Slot/Cell 2—if the I/E Port is enabled
ƒ Slot/Cell 1—if the I/E Port is disabled
If your backup application has a cleaning option, be sure to turn
that option OFF.
You do not have to use the library's Autoclean option to clean the tape
drive(s). You can choose from several other cleaning methods, including
using your backup application's cleaning function and using commands
available through the operator panel. See
these cleaning alternatives.
Activating the cleaning cartridge cell
Enabling the Autoclean option
M
AGNUM
S
ETTING
Lib Maint Drive
T D C
APE RIVE LEANING
page 128
224, S L T24,
TORAGE IBRARY OR
C O
ONFIGURATION PTIONS
for information about
S L 2U
TORAGE OADER
59