Tandberg Data Magnum 224 Product Manual page 255

This appendix defines error messages that may appear on the library's front
panel and provides corrective actions.
Most library components can be replaced only by Tandberg Data-approved service
Caution
providers. If you cannot find an obvious cause for the problem, contact your
service provider. Do not attempt to replace any components other than the tape
drive(s) or the magazine(s). If you do, you will void your warranty.
! ! ! ! Some corrective actions advise you to reset or power the library off and back on.
Important
To avoid disrupting communication between the host computer and other devices
on the bus, make sure that there is no activity on the bus before you reset or
power off the library.
If you need to power the library off, first unload the cartridge from the tape
drive(s), if possible. If you power the library off and back on while a cartridge is in
a tape drive, the tape drive may have to perform a lengthy format recovery
process.
L LCD E
IBRARY RROR
This section describes the general error messages that can appear on the
library's operator panel and provides corrective actions.
Table E-1
If the corrective action in the table...
Instructs you to reset the
library or tape drive
Does not correct the error contact technical support at
.
A 2007
UGUST
M
ESSAGES
lists library error messages in alphabetical order.
go
the Important note above.
or your service provider.
M 224, S
AGNUM
E
E M
RROR
to"Resetting the Library" on page
L T24, S
TORAGE IBRARY OR TORAGE
ESSAGES
134. Also see
www.tandbergdata.com
L 2U
OADER
237