Tandberg Data Magnum 224 Product Manual page 257

Hide thumbs Also See for Magnum 224:
Table of Contents

Advertisement

Table E-1 Library error messages (continued)
Error Message
Circuit Failure
Command Error
Communication
Create File Fail
Device Not Ready
Dir Create Fail
Disabled
Drive Command
Drive Communication The library is unable to
A
2007
UGUST
Description
The library has detected a
problem within its electronic
circuitry.
The options for the
command were incorrect.
The library is unable to
communicate with the tape
drive.
See
"File Create Fail" on page 241
The library is not ready to
perform the requested
operation because it is
performing diagnostics or its
power-on self-test (POST).
The library could not create
a new directory on the USB
device.
Sequential mode is not
enabled.
A command issued from the
library to the tape drive
failed.
communicate with the tape
drive.
M
AGNUM
Corrective Action
1.
Power cycle the library.
2.
If the error persists, contact Technical Support
or your service provider.
1.
Verify that the options for the command are
valid. If they are not, correct the problem and
retry the command.
2.
If they appear to be correct and the error
persists, contact Technical Support (see
page
iii) or your service provider.
Check the ADI interface cabling and
configuration. See
"Connecting to SCSI" on
page
17.
Wait until the library has finished, and then retry
the operation.
1.
Ensure that the USB device is securely
inserted and retry the operation.
2.
Retry with another USB device.
If the error persists, contact Technical Support
(see
page
iii) or your service provider.
Sequential mode has been disabled during
execution of a sequential motion. Operator may
need to unload cartridges using the front panel.
See
"Removing Cartridges from the Library" on
page
122.
ƒ Check the ADI interface cabling and
configuration.
See
"Connecting to SCSI" on page
ƒ Verify that the tape drive is operating correctly.
See:
"Tape Drive Troubleshooting" on
page
196.
Check the ADI interface cabling and
configuration. See
"Connecting to SCSI" on
page
17.
224, S
L
T24,
TORAGE
IBRARY
OR
T
A
F
APE
LERT
LAGS
17.
S
L
2U
TORAGE
OADER
239

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storagelibrary t24Storageloader 2u lto

Table of Contents