Tandberg Data Magnum 224 Product Manual page 115


See
the cleaning cartridge "count" (number of cleanings remaining).
C
You can change the following settings:
NET This option allows you to change the Ethernet addresses.
SNMP If you need to identify the library's SNMP settings to an application,
you can view the settings and change them, if desired.
A 2007
UGUST
d. d. d. d.
Click the Update button.
Via the front panel—See
to set the Autoclean option.
"Check the Cleaning Cartridge Status" on page 129
E
HANGING THERNET
Setting Description
To change these setting via the front panel, see
Ethernet Configuration Options" on page
Static IP If you are using static addressing (DHCP off), specify the values
for this address. If you are using dynamic addressing, specify 0
for this address.
Subnet If you are using static addressing (DHCP off), specify the values
Mask for this address. If you are using dynamic addressing, specify 0
for this address.
Gateway If you are using static addressing (DHCP off), specify the values
for this address. If you are using dynamic addressing, specify 0
for this address.
DHCP If you are using dynamic addressing (DHCP on), this field
indicates the IP address. The default setting for the library is
DHCP enabled.
Note:
M
AGNUM
S
page 59 for information about using the front panel
C
ONFIGURATIONS
If the DHCP address changes during your session, you
will need to check the new address on the library's
LCD (see page 137) and re-direct your browser to the
new address.
224, S L T24,
TORAGE IBRARY
C O
ETTING ONFIGURATION
for information about
"Setting
63.
S L 2U
OR TORAGE OADER
PTIONS
97