Tandberg Data Magnum 224 Product Manual page 261

Table E-1 Library error messages (continued)
Error Message
I/E Port Unlocked
Invalid Cartridge
Invalid Data
Invalid NVRAM
Invalid Password
Magazine Unlocked
No Cleaning Tape
No Empty Cell
A 2007
UGUST
Description
Import/Export element is
unlocked.
An attempt was made to
load an incompatible
cartridge or a spent cleaning
cartridge into a tape drive
and the cartridge was
ejected.
The library detected that the
data read from the USB file
is not the desired data.
An operation couldn't be
completed because the
stored parameters are not
valid.
The password you entered
does not match the saved
password that is protecting
this system.
Magazine is unlocked.
The library cannot clean the
tape drive since there is no
cleaning cartridge in the
fixed cleaning cell.
The requested move cannot
be completed because there
is no empty cell to act as the
destination for the move.
M
AGNUM
Corrective Action
Close I/E Port and retry the operation.
See "Loading Cartridges into the I/E Port" on
page 116.
ƒ Remove the cartridge from the library and
replace it with one that is compatible with the
tape drive. See "Tape drive cartridge read/write
compatibility" on page
ƒ If you were attempting to import a cleaning
cartridge, insert a cartridge with cleaning cycles
remaining on it.
1. Ensure that the correct data is in the file,
re-write the file to the USB device, and retry
the operation.
2. Retry with another USB device.
If the error persists, contact Technical Support
(see page iii) or your service provider.
1. Reset the library and retry the operation.
2. Use "Restore Defaults" from the Library
Settings menu to refresh the library settings.
3. If the error persists, contact Technical Support
or your service provider.
Enter the valid password.
See "Setting up an operator panel password" on
page 73.
Close the magazine and retry the operation.
See "Loading Cartridges into a Magazine" on
page 120.
Import an LTO cleaning cartridge and then move
it to the fixed cleaning cell.
Use only LTO cleaning cartridges with LTO tape
drives.
See "Inserting and Moving Cartridges" on
page 116.
ƒ Use either SCSI or front panel commands to
empty a cell and retry the command.
ƒ Select a different type of element as the
destination.
224, S L T24,
TORAGE IBRARY OR
T A F
APE LERT LAGS
115.
S L 2U
TORAGE OADER
243