Tandberg Data Magnum 224 Product Manual page 170

C 6—V L
HAPTER IEWING IBRARY
For instructions on how to assign one of the tape drives to act as the SCSI
interface (bridge), see
Note:
To check a tape drive's SCSI interface (bridge) assignment:
1. 1. 1. 1.
2. 2. 2. 2.
3. 3. 3. 3.
4. 4. 4. 4.
5. 5. 5. 5.
P M
RODUCT ANUAL
152
I
NFORMATION
"Tape Drive SCSI Interface (Library Bridge)" on page
The library communicates with the host through the SCSI interface of the
tape drive(s) via the ADI serial interface. The SCSI interface as seen by the
host is the SCSI interface of the tape drive.
See the tape drive Product Manual for tape drive information.
See Automation/Drive Interface - Command (ADC) for ADI information.
At the Home screen, press Drive.
If necessary, enter the operator panel password (see
Press until the selection arrow (
Drive
Drive ID
Interface
Drive Configuration
Library SCSI Bridge
Press Select.
Library SCSI Bridge
Drive:
Press OK.
Press Back (as needed) to return to the Home screen.
) points to Library SCSI Bridge.
Select Back
nn
Modify OK
50.
page 75).
1017472