Tandberg Data Magnum 224 Product Manual page 192

C 7—M
HAPTER AINTENANCE
3. 3. 3. 3.
The library is now ready to resume operation. The new tape drive defaults to
the following SCSI IDs:
C
You may want to perform a few load and unload operations and back up
several megabytes of data to ensure that the library and the newly installed
tape drive (or tape drives) are communicating correctly.
P M
RODUCT ANUAL
174
Notes: You must install a terminator on the device at the physical end of the
SCSI bus. If one of the tape drives in the library terminates the SCSI
bus, you must install the required terminator on one of the tape
drive's SCSI connectors.
If there are additional devices on the SCSI bus, ensure that only the
device at the physical end of the bus is terminated.
The library communicates with the host through the SCSI interface of
one of the tape drive via the Automation Drive Interface (ADI) serial
interface.
See the tape drive's Product Manual for tape drive information.
IBM — www.storage.ibm.com/tape/lto/oem/index.html
Hewlett Packard —
See Automation/Drive Interface for ADI information:
Reconnect the power cord and power on the library (press the
of the unit), and then power on the host.
Tape Drive Configuration
Single half height tape drive
Two half height tape drives
Full height tape drive
! ! ! ! You may need to reconfigure your backup application to
Important
recognize the new tape drive. Refer to your application's
documentation for instructions.
I
ONFIRMING THE NSTALLATION
Use LibTool to
Use LTOTool to
www1.hp.com/storage/tapestorage.html
Upper tape drive
Lower tape drive
Detect the library
View the library's cartridge inventory
Move tapes into and out of the tape drive
Detect the tape drive
Perform a Read/Write test
www.T10.org
on the back
I
SCSI ID
3
4
3
3
1017472