Maintenance; Installing Or Replacing A Tape Drive - Tandberg Data Magnum 224 Product Manual

This chapter describes basic library maintenance tasks that you can perform
on-site without the aid of a service technician. .
Do not attempt to replace any components in the library, other than the tape
Caution
drive. If you do so, you will void your warranty.
I R
NSTALLING OR EPLACING A
This section describes how to install or replace a tape drive in the library. Please
read
and the entire section that you are using prior to beginning the procedure.
P
Note:
A 2007
UGUST
To view this information...

Installing or replacing a tape drive

Removing cartridges without power – from the library or tape drive
Cleaning the library
Tape drive diagnostics – running a self test
Library diagnostics – running system tests and demos
Upgrading library firmware
Creating library diagnostic listings
Upgrading tape drive firmware and
creating diagnostic listings
Upgrading tape drive firmware
T D
APE
Preparing for Installation or
I
REPARING FOR NSTALLATION OR
If your library is installed in a rack, it is not necessary to remove the library
from the rack to complete this procedure. It is also not necessary to
M
AGNUM
7
M
using LibTool
using the USB port
Using FTP
using the USB port
using LTOTool
using the USB port
RIVE
Replacement, the
R
EPLACEMENT
224, S L T24,
TORAGE IBRARY
AINTENANCE
go to...
below
page 175
page 176
page 176
page 178
using FTP page 185
page 186
page 186
page 185
page 187
page 189
page 190
General Information section,
S L 2U
OR TORAGE OADER
159