C
3—C
HAPTER
ONFIGURING THE
Table 3-7 Ethernet configuration options (continued)
Enabling Network Addressing and Setting the Ethernet Addresses
To enable or disable Network addressing:
1. 1. 1. 1.
2. 2. 2. 2.
P
M
RODUCT
ANUAL
64
L
IBRARY
SNMP
If you are using a network-based monitor/management
application other than the library's Remote Management utility,
you may need to identify the library's Simple Network
Management Protocol (SNMP) settings to the application. These
settings include:
Read community string
Write community string
Broadcast community string
Trap address
Trap port
You can view and change these settings only through the
library's Remote Management utility. See
instructions.
FTP Interface
The library also includes an FTP interface that you can use to
transfer firmware files or create diagnostic listings. You can:
Set up an FTP user name and password for this interface or
use the library's defaults
View and change the FTP settings only through the library's
Remote Management utility
For instructions, see
For information about accessing the library's FTP interface and
using an FTP utility to upgrade firmware or obtain diagnostic
listings, see
At the Home screen, press Lib.
If necessary, enter the operator panel password (see
Press
until the selection arrow (
Library
Library ID
Inventory
Password
X
Select Language
Library Settings
Chapter
4.
page
183.
) points to Library Settings.
Select
Back
Chapter 4
for
page
75).
1017472