Tandberg Data Magnum 224 Product Manual page 70

C 3—C
HAPTER ONFIGURING THE
2. 2. 2. 2.
3. 3. 3. 3.
4. 4. 4. 4.
5. 5. 5. 5.
P M
RODUCT ANUAL
52
L
IBRARY
If necessary, enter the operator panel password (see
Press until the selection arrow (
Drive
Drive ID
Interface
Drive Configuration
Library SCSI Bridge
Press Select.
Drive Configuration
1: IBM LTO FullHigh
2: no drive
Note: The library lists "no drive" only if there is no room for more tape
drives. For example, in the above screen, the library has one full
height tape drive installed. The two tape drive number is for two half
height tape drives.
Press Modify. Press
desired configuration. Press Select.
Select Drive 1
HP LTO HalfHigh
TANDBERG LTO HH
IBM LTO FullHigh
Notes: This menu option requires input for all of the tape drives installed in
the library. If you press "Back" before configuring all the tape drives,
the configuration selection will not change.
Press OK. Repeat the process for each tape drive installed.
) points to Drive Configuration.
Select Back
Modify
or until the selection arrow (
Select Back
page 75).
OK
) points to the
1017472