Tandberg Data Magnum 224 Product Manual page 67

C
Each device on a SCSI bus must have a unique SCSI ID so that it can be
identified by the host computer. You can use the default IDs for the tape
drive(s) or change them if they conflict with other devices on the SCSI bus.
Notes:
To change the tape drive's SCSI ID:
1. 1. 1. 1.
2. 2. 2. 2.
3. 3. 3. 3.
A 2007
UGUST
SCSI ID
HANGING THE
The library communicates with the host through the SCSI interface of the
tape drive(s) via the ADI serial interface. The SCSI interface as seen by the
host is the SCSI interface of the tape drive.
See the tape drive Product Manual for tape drive information.
See Automation/Drive Interface - Command (ADC) for ADI information.
If you change the tape drive's SCSI ID after the library has been in
operation, you may need to reboot your host computer so that it
recognizes the new ID.
At the Home screen, press Drive.
If necessary, enter the operator panel password (see
Press until the selection arrow (
Drive
Drive ID
Interface
Drive Configuration
Library SCSI Bridge
Press Select.
Interface
Source Drive
01
Address: 0051 (element address)
Drive 1: (empty)
–
M
AGNUM
S
ETTING
S
) points to Interface.
Select
02
+
Select
224, S L T24,
TORAGE IBRARY OR
C O
ONFIGURATION PTIONS
page 75).
Back
Back
S L 2U
TORAGE OADER
49