Tandberg Data Magnum 224 Product Manual page 151

3. 3. 3. 3.
4. 4. 4. 4.
5. 5. 5. 5.
6. 6. 6. 6.
! ! ! !
A 2007
UGUST
Press until the selection arrow (
press Select.
Clean Drive: Source
Slot: n: CLNA02
–
+ –
Press or to select the "source" slot where the cleaning cartridge is
located (either a slot or the I/E Port), and then press Select.
Clean Drive
Destination Drive
01
Drive n:
–
+ –
Press or to toggle between tape drives (if more than one tape drive is
installed), and then press Select.
Pending Action:
Clean Drive
I/E Port nn
Press OK to clean the tape drive, or Back to cancel the action.
If there are no more cleaning cycles remaining on the cleaning
Important
cartridge, the tape drive ejects the cartridge immediately without
performing the cleaning. Remove the cleaning cartridge from the
library and use a new one. Do not rewind and reuse the material
in a cleaning cartridge. Reusing the material may redistribute
contaminants previously removed from the tape path.
M
AGNUM
) points to Clean Drive, and then
+
Select Back
02
+
Select
Drive nn
OK
224, S L T24,
TORAGE IBRARY OR
C T
LEANING THE APE
Back
Back
S L 2U
TORAGE OADER
133
D
RIVE