Tandberg Data Magnum 224 Product Manual page 153

Resetting the library from the operator panel or powering the library off and
back on causes it to perform its power-on self-test and a cartridge inventory.
Powering the library off and back on to reset the tape drive(s) cause the tape
drive to perform a power-on self-test and to rewind a loaded tape to the
beginning.
! ! ! !
To reset the library from the operator panel:
1. 1. 1. 1.
2. 2. 2. 2.
A 2007
UGUST
If you need to power the library off, first unload the cartridge from
Important
the tape drive(s), if possible. If you power the library off and back
on while a cartridge is in a tape drive, the tape drive may have to
perform a lengthy format recovery process.
If a cartridge is loaded in a tape drive when the library is powered
off and back on, the tape drive rewinds the tape but does not eject
the cartridge. Make sure that it is safe to overwrite the tape before
performing a backup so that you don't lose previously recorded
data. If necessary, unload the cartridge as described on
Before resetting, make sure that the library or tape drive is not
communicating across the bus. The reset may disrupt
communications on the bus.
At the Home screen, press Maint.
If necessary, enter the operator panel password (see
Press until the selection arrow (
Maintenance
Library Maintenance
Drive Maintenance
Cleaning Options
System Reset
USB Options
M
AGNUM
) points to System Reset.
Select
224, S L T24,
TORAGE IBRARY OR
R L
ESETTING THE IBRARY
page
page 75).
Back
S L 2U
TORAGE OADER
135
127.