Table of Contents
Advertisement
Table E-1 Library error messages (continued)
Error Message
Owned by E-Net
Owned by Panel
Picker Ship-lock
POST Failed
Power Fan
Report Illegal Request The I/E port door is
Reserve Failed
Reset Will Occur!
Right Cable
Robot Empty
A
2007
UGUST
Description
The library is executing a
command issued from the
Remote Management utility
(see
Chapter
4) when a
command is issued from the
operator panel.
The library is executing a
command issued from
operator panel when a
command is issued from the
Remote Management utility
(see
Chapter
4).
The robot could not move
because it may be locked in
place by the shipping lock.
The library encountered an
error during its power-on
self-test.
The library has detected that
the power fan is not
operating properly.
unlocked.
The library could not reserve
the USB device resources.
When the operation
completes, the library will
reset itself as if a
power-cycle had occurred.
The library detected an error
with the right-side cable.
The robot is unexpectedly
empty
M
AGNUM
Corrective Action
Wait until the library has finished its current
operation, and then retry the operation.
Wait until the library has finished its current
operation, and then retry the operation.
Remove the shipping lock (see
1.
Reset the library and retry the operation. See
page 134
for reset instructions.
2.
If the error persists, contact Technical Support
(see
page
iii) or your service provider.
1.
Power cycle the library.
2.
If the error persists, contact Technical Support
or your service provider.
Lock the I/E port door (press it firmly toward the
library) and retry the operation.
When the I/E port door is locked, the lock icon
illuminates solid green ( ).
1.
Retry the operation.
2.
Reset the library and retry the operation. See
page 134
for reset instructions.
If the error persists, contact Technical Support
(see
page
iii) or your service provider.
ƒ If the operation has not started, proceed with
the operation only if the reset will not cause a
problem.
ƒ If the operation is underway, no action is
necessary; the machine will reset itself.
Contact Technical Support (see
service provider.
1.
Reset the library and retry the operation. See
page 134
for reset instructions.
2.
If the error persists, contact Technical Support
(see
page
iii) or your service provider.
224, S
L
T24,
TORAGE
IBRARY
OR
T
A
F
APE
LERT
LAGS
page
22).
page
iii) or your
S
L
2U
TORAGE
OADER
245
Advertisement
Chapters
Table of Contents
Troubleshooting
