Tandberg Data Magnum 224 Product Manual page 68

C 3—C
HAPTER ONFIGURING THE
4. 4. 4. 4.
5. 5. 5. 5.
6. 6. 6. 6.
7. 7. 7. 7.
T
If you have two tape drives installed in the library, you can assign one of them
to act as the primary SCSI interface (bridge) for the library. If you have only
one tape drive installed, it automatically acts as the SCSI bridge.
Note:
To assign the tape drive SCSI bridge:
1. 1. 1. 1.
2. 2. 2. 2.
P M
RODUCT ANUAL
50
L
IBRARY
+ –
Press or to select the tape drive (if your library has more than one tape
drive installed). Press Select to see the following screen.
Drive SCSI ID
Drive 01
SCSI ID: n
+
Press Modify. Press
and then press Select.
Press OK.
Press Back (as needed) to return to the Home screen.
D SCSI I
APE RIVE NTERFACE
The library communicates with the host through the SCSI interface of the
tape drive(s) via the ADI serial interface. The SCSI interface as seen by the
host is the SCSI interface of the tape drive.
See the tape drive Product Manual for tape drive information.
See Automation/Drive Interface - Command (ADC) for ADI information.
At the Home screen, press Drive.
If necessary, enter the operator panel password (see
Press until the selection arrow (
Drive
Drive ID
Interface
Drive Configuration
Library SCSI Bridge
Modify
–
or until the selection changes to the desired value,
(L B
IBRARY RIDGE
) points to Library SCSI Bridge.
Select
Ok
)
page 75).
Back
1017472