Presets Tab - Lightware MMX8x4-HT420M User Manual

   
6. Software Control – Lightware Device Controller
6.9. Presets Tab
The matrix has six user-programmable presets. Each preset stores a configuration regarding the crosspoint
and mute state for all inputs/outputs. All presets are stored in a non-volatile memory; the router keeps
presets even in the case of power down. The presets can be run from the front panel or by sending protocol
commands, too.
Loading a Preset
Step 1. Select the Presets tab from the Crosspoint menu.
Step 2. Select the desired preset; check the Preview panel and press the Load button. Press Yes in the
confirmation window.

INFO: Presets which were saved by the front panel buttons previously are listed with names Preset1..
Preset8 as default. See the corresponding Save or Load a Preset section.
Applied firmware package: v1.3.0 | LDC software: v2.4.2
MMX8x4-HT series – User's Manual
Saving a Preset
Step 1. Arrange the desired crosspoint connections.
Step 2. Select the Presets tab from the Crosspoint menu and choose a target preset slot from Preset 1.
.Preset 6. Type the desired Preset name in the indicated text field up to 16 characters. The followings
are allowed when naming: letters (A-Z and a-z), hyphen (-)underscore (_), and numbers (0-9).
Confirm it with Rename Preset button.
Step 3. Press the Save button and Yes to confirm for storing the configuration.
Renaming a Preset
Step 1. Select the desired preset you want to rename.
Step 2. Type the desired name and press the Rename Preset button.
Deleting a Preset
Step 1. Select the desired preset you want to delete.
Step 2. Press the Clear button and Yes to confirm
Auto Load Mode
When the Auto Load button is highlighted with green, the mode is active. In this case,
confirmation is not required: the selected preset is loaded immediately when the
button is pressed.
Load
72
Save
Rename preset
Clear
Auto Load