Cleartext Login Protection; Setting The Login Password; Login The Device; Logout From The Device - Lightware MMX8x4-HT420M User Manual

   
8. LW3 Programmers' Reference
8.5. Cleartext Login Protection
DIFFERENCE:
This feature and below commands are available from firmware v1.3.0.
This cleartext login tool allows setting a password for login, thus, any change in the device can be performed
only after a successful login – coming from any control interface (RS-232, Ethernet, etc...). The login is valid
until a TCP socket break in case of Ethernet connection.

INFO: The login password is erased and the login is disabled when restoring the factory default values.
The following can be queried without login:
ProductName
▪
PartNumber
▪
▪ SerialNumber
FirmwareVersion
▪
PackageVersion
▪
▪ MacAddress
8.5.1. Setting the Login Password
Command and Response
ç CALL·/LOGIN:setPassword(<password>)
æ mO·/LOGIN:setPassword
Example
ç CALL /LOGIN:setPassword(pr0t3ctED)
æ mO /LOGIN:setPassword
8.5.2. Login the Device
Command and Response
ç CALL·/LOGIN:login(<password>)
æ mO·/LOGIN:login
Example
ç CALL /LOGIN:login(pr0t3ctED)
æ mO /LOGIN:login
After a successful login, the LoggedIn property becomes true and the LW3 tree is available.
MMX8x4-HT series – User's Manual
#login
Applied firmware package: v1.3.0 | LDC software: v2.4.2
8.5.3. Logout from the Device
Command and Response
ç CALL·/LOGIN:logout(<password>)
æ mO·/LOGIN:logout
Example
ç CALL /LOGIN:logout(pr0t3ctED)
æ mO /LOGIN:logout
After a successful logout, the LoggedIn property becomes false and the LW3 tree is protected.
8.5.4. Enable the Cleartext Login Function
ATTENTION!
This property can be changed only, if the LoggedIn property is true.
Command and Response
SET·/LOGIN:LoginEnable=<login_state>
ç
pw·/LOGIN.LoginEnable=<login_state>
æ
Parameters
If the <login_state> parameter is true (or 1), the Cleartext login function is enabled, if the parameter is false (or
0), the function is disabled. Please note that the function can be enabled without setting a password by the
setPassword method.
Example
ç SET /LOGIN.LoginEnable=true
æ pw /LOGIN.LoginEnable=true
110