Tcp Recognizer - Lightware MMX8x4-HT420M User Manual

   
5. Device Concept
Ethernet Interface - Example
The concept
In the room 1. the Matrix reaches the LAN by connecting the Control Ethernet port to the Ethernet switch.
Creating a link between the RJ45 connectors labeled Ethernet Link to TPS inputs and TPS inputs Ethernet makes
possible to support TPS input ports (I1-4) with Ethernet.
In the room 2. a third-party Ethernet device connects to the TPS input port (I2). In this case, instead of TPS
data transmission the TPS connection provides only Ethernet connection to the LAN.
In the room 3. the TPS extender connects to the TPS input port (I4)of the Matrix. Besides the TPS data
transmission, the TPS extender provides connection to the LAN for e.g. a laptop.
Settings
Matrix: TPS modes in TPS input ports (I2, I4) can be set Auto. ETH Link TPS In (P4), TPS IN2 (P6), TPS IN4
(P8) can be enabled.
Ethernet and TPS Connectors for LAN
MMX8x4-HT series – User's Manual
5.5.1. TCP Recognizer

DIFFERENCE:
The feature is almost the same as in case of the RS-232 but for the network interface: the incoming TCP
messages can be processed which may trigger actions. The combination of the TCP recognizer and the
Event Manager gives numerous opportunities for creating automatic room solutions.
TCP Recognizer Example
When the Projector switches off, the button light (1) of the TBP6-EU button panel is turned off automatically.
When the power-off process is started in the projector, it will send a message over Ethernet. That message
will be recognized by the matrix switcher and will be used as a Condition in Event Manager.
How to setup the switcher?
Step 1. Configure the recognizer for the communication by the LDC, see the
Step 2. Create the following event in the Event manager:
For more information about setting the events in LDC, see the
Applied firmware package: v1.3.0 | LDC software: v2.4.2
Below mentioned features are available from FW package v1.3.0.
Recognizer) section or by LW3 protocol commands (see the
Define the desired device as a TCP client. (The Projector is saved as 'C1' in this example.)
E1. When the (PWR!001 "On") message is recognized from the C1 client, the GPIO pin 1 is set to
low level.
45
TCP Clients (TCP Message
TCP Message Recognizer section).
Event Manager section.