Output Lock; Control Lock; Save Or Load A Preset - Lightware MMX8x4-HT420M User Manual

   
3. Front Panel Control
3.3.5. Output Lock
ATTENTION!
However, the front panel buttons allow to lock only the output ports, the input ports can
also be locked by using Lightware Device Controller software (see
section) or sending LW3 protocol command (see
Using Lightware routers it is possible to lock a destination. This feature prevents an accidental switching to
the locked destination in case of an important signal. Locking a destination means that no input selection or
muting action can be executed on that particular
Destinations can be independently locked or unlocked. Locking a destination does not affect other
destinations.
Output Lock in Take Mode
Step 1. Press and release the Output Lock button; it starts to blink and all the buttons of any locked destinations
light up (view state).
Step 2. Press and release a destination button; it starts to blink (more destinations can be selected sequentially).
Step 3. Press and release Take button. The selected destinations are now locked.
Output Lock in Autotake Mode
Step 1. Press and release the required destination button. Now the selected destination button and the
currently configured source button light up (view mode).
Step 2. Press and release the Output Lock button; it lights up in red, and lock function is activated at once. No
source can be changed at the locked
HDMI and TPS Output Port Properties
Lock an Output Port section).
destination. #buttonlock #lockbutton
destination. #buttonlock #lockbutton
Applied firmware package: v1.3.0 | LDC software: v2.4.2
MMX8x4-HT series – User's Manual
3.3.6. Control Lock
Front panel button operation can be enabled or disabled using Control Lock button, while the remote control
is still enabled. If the button is unlit, front panel button operation is enabled. If the button is continuously
illuminated in red the front panel operations are not possible. Press and keep the Control Lock button pressed
for three seconds to toggle between the control lock states.
3.3.7. Save or Load a Preset
The matrix can store user-programmable presets. Each preset stores a configuration regarding all input
connections for all outputs. All presets are stored in a non-volatile memory; the router keeps the presets
even in the case of a power down. Please note, that preset operations can be followed on the LCD during
front panel preset operations.

ATTENTION! Eight of the memory slots are available by the Source buttons; see
details.
Saving a Preset in Take Mode
Step 1. Press and release Save Preset button.
Step 2. Press and release the desired source (memory address) button (source 1 to 8).
Step 3. Press and release the Take button. Now the current configuration is stored in the selected memory.

ATTENTION! Preset save action always stores the current configuration for all outputs.
26
#buttonlock #lockbutton
Presets Tab for the