Microphone Input Channel; Legend Of Microphone Input Channel - Lightware MMX8x4-HT420M User Manual

   
6. Software Control – Lightware Device Controller
6.8.7. Microphone Input Channel
t
r
e
w
3 4
1 2
5
6
7
8
9
#analogaudio #balance
#volume #advancedaudio
q
#mic #microphone
MMX8x4-HT series – User's Manual
6.8.8. Legend of Microphone Input Channel
1
2

ATTENTION!
is connected!
3
4
5
6
7
8
9
q
w
e
r
t

ATTENTION!
in Installation Guide for Connecting a Microphone
Applied firmware package: v1.3.0 | LDC software: v2.4.2
Channel name Displays the channel name. All the settings below belongs to the channel.
Phantom power Keep pressed the button for more then 2 sec to switch on and off the 48V DC. It
button gives remote powering via the microphone cable to the condenser microphones.
Application of the phantom power can cause a damage if dynamic or wireless microphone
Phase invert It inverts the phase of the input signal.
button
Feedback Turning on this feature hides the Feedback phenomenon. Before applying this
button button, check if gain or the volume could be decreased.
Preset Button Clicking on this button opens a Mic Input Channel Preset window. For more details
see Channel Presets section.
Gain section GAIN setting is for increase (or decrease) the input microphone signal level,
expressed in dB. For more information see the
HPF button High-pass filter lets pass the microphone signals above 100Hz frequency. Click on
the button to toggle turn it on and off.
LPF button Low-pass filter lets pass the microphone signals under 15kHz frequency. Click on
the button to toggle turn it on and off.
EQ section: The equalizer section is
HIGH, HMID, frequencies (high: 12kHz; high-mid: 1.6 kHz, low-mid: 400Hz, low: 120Hz).
LMID, LOW For more details, see Equalization (EQ)
Mic preset Five factory presets are available for microphone input channel. These are
specialized for the most common microphone types. For more details see
MIC presets section.
Factory defaults Restore the factory default settings on te microphone channel. For more details
button see Factory Default Settings.
Input volume Sets the volume of the input microphone signal between -80dB and +10dB. It also
fader can be controlled by scrolling or writing the value in the text field.
Signal indicator This section gives a feedback about the actual level of the input signal. See more
chart details in Panorama or Balance Settings
Mute/Unmute Mutes/unmutes the microphone input.
Panorama This setting defines, that the balanced microphone input is transmitted to the left
section or right channel of the balanced analog output. For more details, see
Balance Settings.
Improper setting could damage the device! See more details about connect the microphone
section.
67
Gain Settings.
for set the proper rate of the different
Settings.
Factory
section.
Panorama or