Set The Subnet Mask; Set The Gateway Address; Apply Network Settings; Gpio Settings - Lightware MMX8x4-HT420M User Manual

   
7. LW2 Programmers' Reference
7.5.3. Set the Subnet Mask
Subnet mask can be set as follows.
Command and Response
 {IP_NETMASK=<subnet_mask>}
 (IP_NETMASK=<subnet_mask>)CrLf
Parameters
See the Query the Current IP Status
Example
 {ip_netmask=255.255.255.0}
 (IP_NETMASK=255.255.255.0)
INFO:
The subnet mask can be queried by typing the "ip_address=?" command. The response contains
the fix IP subnet mask that is stored in the device even if DHCP is enabled; in this case, this IP subnet
mask is not valid.
7.5.4. Set the Gateway Address
Gateway address can be set as follows.
Command and Response
 {IP_GATEWAY=<gateway_addr>}
 (IP_GATEWAY=<gateway_addr>)CrLf
Parameters
See the Query the Current IP Status
Example
 {ip_gateway=192.168.0.50}
 (IP_GATEWAY=192.168.0.50)

INFO: The gateway address can be queried by typing the "ip_gateway=?" command. The response
contains the static IP gateway address that is stored in the device even if DHCP is enabled. In that case,
the latest valid gateway address (for static IP) is stored.
7.5.5. Apply Network Settings
Apply the network settings and restart the network interface.
Command and Response
 {ip_apply}
 (IP_APPLY)CrLf
Example
 {ip_apply}
 (IP_APPLY)
section.
section.
MMX8x4-HT series – User's Manual
7.6. GPIO Settings
DIFFERENCE:

7.6.1. Set GPIO State
GPIO state can be changed.
Command and Response
 {GPIO<port_nr>=<direction>;<output_level>}
 (GPIO<port_nr>=<direction>;<output_level>)CrLf
Parameters
<direction>
<output_level>
Example
 {GPIO1=I;H}
 (GPIO1=I)
INFO:

7.7. Relay Settings
DIFFERENCE:

7.7.1. Set Relay Connection State
Command and Response
 {RELAY<port_nr>=<direction>;<state>}
 (RELAY<port_nr>=<direction>;<state>)CrLf
Parameters
<direction>
<state>
Example
 {RELAY1=O;O}
 (RELAY1=O;O)
INFO:

Applied firmware package: v1.3.0 | LDC software: v2.4.2
This command is available in MMX8x4-HT420M and MMX8x8-HDMI-4K-A-USB20 models.
#gpio
Identifier Parameter description
Direction of the signal
Current level of the pin
The GPIO state can be queried by typing the {GPIO<port_nr>=?} command.
These commands are available in MMX8x4-HT420M model.
#relay
Identifier Parameter description
Direction of the signal
Current state of the pin
The RELAY state can be queried by typing the {RELAY<port_nr>=?} command.
102
Parameter values
I: input
O: output
H: high
L: low
Parameter values
O: it is always O (output)
O: opened
C: closed