The Default Status Page; Miniweb Customization - Lightware MMX8x4-HT420M User Manual

   
6. Software Control – Lightware Device Controller
6.15.2. The Default Status Page
If there is no control page uploaded, the default status page will be displayed (which is also available by
opening the <IP_address>/status.html address). This page works without login either.
The Factory Default Status Page (status.html)
6.15.3. Miniweb Customization
The buttons of Action triggers section are linked to Actions of certain Events in the Event Manager. These
buttons are displayed only for specific events:
▪ Any Event which does not have the @W suffix in its name will not be displayed as a trigger button.
▪ The displayed trigger buttons will get a text label with the event name except the suffix.
To add the desired Action as a button, append the name of the desired Event with the @W characters - see
below (type uppercase for 'W' as it is case-sensitive):
Action Trigger Button added in the Event Manager and displayed in the Control Page
MMX8x4-HT series – User's Manual
Customized HTML
The default control page can be replaced in the LDC; navigate to the Settings/Status page. Custom HTML file
can be uploaded by pressing the Choose file button. Pay attention to the size of the HTML file. Only one file is
allowed and the maximum file size is 10 KB (in case of SW4-TPS-TX240-Plus it's 80 KB).
Press the Reset button to remove the control page. The default control page can be restored during a firmware
upgrade process, see the
Applied firmware package: v1.3.0 | LDC software: v2.4.2
Step 3 – Check the upgrade parameters section.
The Built-in Miniweb Section in LDC
93