Hdmi And Tps Output Port Properties - Lightware MMX8x4-HT420M User Manual

   
6. Software Control – Lightware Device Controller
6.5.3. HDMI and TPS Output Port Properties

DIFFERENCE: Only the MMX8x4-HT420M model contains a TPS output port.
TPS Output Port Properties Window
MMX8x4-HT series – User's Manual
Available Settings
Mute/unmute the port;
▪
Lock/unlock the port;
▪
▪ Autoselect settings (see below)
▪ Signal type (Auto / DVI / HDMI);
HDCP mode (Auto / Always): The matrix forces the source sent the signal without encryption if the
▪
content allows when Auto mode is selected.
▪ PWR5V mode (Auto / Always on / Always off): The setting lets the source and the sink devices be
connected – independently from the transmitted signal;
▪ Send and receive Consumer Electronics Control (CEC) commands by the
▪ No sync screen: Test pattern configuration settings; see more details in the
Sync Screen
Audio mode (only in O2 and O4 ports of MMX8x8-HDMI-4K-A model);
▪
TPS mode* (Auto / HDBaseT / Longreach / LPPF1 / LPPF2 ). See more details about this setting in
▪
TPS Interface
▪ PoE setting * (enable / disable): The matrix is able to supply (send remote power) devices through the
TPS input and output ports which are compatible with the PoE standard.
▪ Cable Diagnostics * (in TPS port); For more details see
▪ Reloading the
* TPS-related settings can be found only in TPS output properties window.
Autoselect Settings
Pay attention for the following settings for the proper operation of Autoselect function:
– Be sure that no input is set to the same priority number;
– Be sure that all priority values are filled in (no empty space);
– Be sure that all inputs are enabled with the green checkbox on the right side;
– Always click on the Set priorities button after the changes to launch the new settings;
– Set the Autoselect settings to Enabled.
(See more details about the feature in
Analog audio settings
The settings depend on the selected audio mode; see more details in the
#hdcp #lock #unlock #mute
#tpsmode
Applied firmware package: v1.3.0 | LDC software: v2.4.2
section.
section.
Cable Diagnostics
Factory Default Settings for the selected port.
The Autoselect Feature section.)
#analogaudio #balance #volume
#unmute #portstatus
#diagnostic #framedetector #autoselect #nosyncscreen #testpattern
60
CEC Tool.
Test Pattern Generator - No
the
section.
Analog Audio Input Settings section.