Port Diagram Of Mmx8X4-Ht420M; Port Diagram Of Mmx8X8-Hdmi-4K-A And -Usb20 Models; The Autoselect Feature - Lightware MMX8x4-HT420M User Manual

   
5. Device Concept
5.3.2. Port Diagram of MMX8x4-HT420M
The following figure describes the port diagram of the MMX8x4-HT420M matrix:
5.3.3. Port Diagram of MMX8x8-HDMI-4K-A and -USB20 Models
The following figure describes the port diagram of the MMX8x8-HDMI-4K-A and MMX8x8-HDMI-4K-A-USB20
matrix:
MMX8x4-HT series – User's Manual
5.3.4. The Autoselect Feature
The autoselect mode can be set on output ports for each input with Lightware Device (LDC) Controller
software (see more info about it in
(see more info about it in

INFO:
There are three types of Autoselect as follows:
First detect mode: Selected input port is kept connected to the output while it has an active signal.
Priority detect mode: Always the highest priority active input is selected to transmit.
The proper priority setting requires fulfill the conditions below:
▪ Match the priority to the input ports. 0 means the highest, 7 means the lowest priority. If two inputs
have the same priority number, the lower port number gets higher priority.
Certain inputs can ignore by clicking the green tick or write 31 instead of the priority number. This port
▪
will be not scanned. See more details about this setting in
▪ Always confirm the settings by clicking on Set priorities button.
Last detect mode: Always the last attached input is selected to transmit.
See the Flowchart of Autoselect Modes in the Appendix chapter.
INFO:

autoselect function became also disabled.
Applied firmware package: v1.3.0 | LDC software: v2.4.2
HDMI and TPS Output Port Properties
Change the Autoselect Mode section).
An input port is active if there is a valid signal on it.
Autoselect mode is always disabled on locked output. If the crosspoint is changed manually, the
40
section) or with the LW3 protocol
Query the Input Port Priority section.