Hdmi Input Port Properties - Lightware MMX8x4-HT420M User Manual

   
6. Software Control – Lightware Device Controller
6.5.2. HDMI Input Port Properties
Click on a port to display its properties; Signal status information and the most important parameters are
displayed.
HDMI Input Port Properties Window in MMX8x4-HT420M model
#analogaudio #balance #volume #hdcp #lock #unlock #mute #unmute #portstatus #tpsmode #diagnostic
#framedetector
MMX8x4-HT series – User's Manual
Available Settings
Port name
▪
Mute/unmute the port;
▪
▪ Lock/unlock the port;
HDCP setting (enable / disable);
▪
Audio mode (HDMI audio passthrough / Embed from aux audio / Deembed to aux audio)
▪
Analog Audio Input Settings
The displayed configurable settings depends on the chosen audio mode.

INFO:
4K-A model.
Depending on the chosen audio mode the following parameters can be set:
HDMI audio passthrough
The embedded audio of the HDMI signal will be transmitted without any modification.
Embed from aux audio
Audio embedder is able to add (or replace) an audio stream to an HDMI video.
Mute/unmute
▪
Volume: from 100 to 0%, in step 1% (0 dB to -48.18dB, default is 0 dB)
▪
▪ Balance from L 100 to R 100, in step 1 (default is 0 = center)
▪ Gain from 0.00 to 24.00, in step 1.00 (default is 0.00)
Deembed to aux audio
Audio de-embedder is able to separate the HDMI video and audio.
Mute/unmute
▪
▪ Volume: from 100 to 0%, in step 1% (0 dB to -95.62dB, default is 0 dB)
▪ Balance from -100 to 100, in step 1 (default is 0 = center)
Status and Signal Info
It gives a feedback about the current parameters the of the video signal:
+5V Present / Signal present / Signal type / HDCP
▪
▪ Resolution / Scan / Color depth / Color space
Frame Detector
See more details about the Frame Detector in the
Emulated EDID
Displays the basic information about the emulated EDID.
Other
Reloading
Applied firmware package: v1.3.0 | LDC software: v2.4.2
Audio mode is available at I5, I6 ports of MMX8x4-HT420M and I2, I4, I6, I8, O2, O4 ports of MMX8x8-HDMI-
Frame Detector
Factory Default Settings for the selected port.
59
section.