6. Software Control – Lightware Device Controller
6.11.5. Infra Tab
ATTENTION!
The device has no built-in Infrared transmitter. For the complete usage attach an IR emitter
unit to the IR OUT
connector.
All the infra ports are transmitters and they are able to forward the Infra message, which comes from the
Control Ethernet port (the operation mode is always Command Injection).
The following settings are also available:
▪
Port name
Enable / disable the port;
▪
▪
Port number
▪
Enable / disable command injection
Message sending function (little-endian prontohex code) For more details see the
▪
Codes in Little-endian Format
▪
Reloading factory defaults (see factory default settings in the
#infra #infrared
Infra tab in the Control menu
section.
#message
Factory Default Settings
MMX8x4-HT series – User's Manual
6.11.6. USB Switch Tab
DIFFERENCE:
The following settings are available:
▪
USB Host Select: PC1 / PC2 / PC3 / PC4
One host can be active at the same time from the four.
Enable the Power Switch Delay: After switching the hosts (on USB-B ports), this feature
▪
turns off the 5V power automatically for 2 seconds of all devices (on USB-A ports).
INFO:
after the switching. Enable power switch delay function turns off the 5V power of the connected device
for 2s, and the device restarts.
▪
Host5vSensePc gives feedback about the connected hosts.
▪
Device5VEnable allows sending 5V power to the device.
Sending Pronto Hex
section).
Applied firmware package: v1.3.0 | LDC software: v2.4.2
Only MMX8x8-HDMI-4K-A-USB20 model has this Tab.
After switching between the hosts, some connected USB device needs reset to operate properly
80
#new
#usb