Ethernet - Lightware MMX8x4-HT420M User Manual

   
6. Software Control – Lightware Device Controller
6.11.4. Ethernet
Ethernet Ports
Three ports are displayed in the Ethernet settings: Local, CPU, and TPS*. You can check the status of the
Ethernet line by each ports: the speed and the duplexity of the connection.
The following settings are available for each ports:
Enable / disable the port; **
▪
▪ Reloading factory defaults.
* Only MMX8x4-HT420M and MMX8x4-HT400MC models have TPS Ethernet port.
** CPU Ethernet port cannot be disabled
The Ports tab in the Control/Ethernet menu
MMX8x4-HT series – User's Manual
HTTP Clients (HTTP Post and Put Message Sending)

ATTENTION!
device. Encrypted transmission (HTTPS) is not supported.
The HTTP Clients tab allows sending HTTP post and put messages to the desired server IP:port no. Control
commands can be set to the target device, but it is not suitable for processing the response (e.g. querying a
parameter/status) since the response is just an acknowledge (ACK).
The feature is available also by LW3 commands, see the
When you press the enter in the Http header or Http body text box, the \r\n is added automatically.
Applied firmware package: v1.3.0 | LDC software: v2.4.2
This feature means posting or putting HTTP messages from the Lightware device to another
HTTP Messaging
HTTP Clients tab in the Control/Ethernet menu
78
#http
section.