Setting The Rotary Direction Of The Jog Dial Knob; Running A Macro; Controllock; Resetting The Matrix - Lightware MMX8x4-HT420M User Manual

   
8. LW3 Programmers' Reference
8.4.8. Setting the Rotary Direction of the Jog Dial Knob
Command and Response
SET·/MANAGEMENT/UI.RotaryDirection=<direction>
ç
pw·/MANAGEMENT/UI.RotaryDirection=<direction>
æ
Parameters
Parameter Parameter description
<direction> The rotary direction of
the jog dial knob
Example
ç SET /MANAGEMENT/UI.RotaryDirection=0
æ pw /MANAGEMENT/UI.RotaryDirection=0
8.4.9. Running a Macro

DIFFERENCE: This command is available from FW package v1.3.0.

DEFINITION: Macro is a batch of pre-defined commands stored in the
You can create your custom macros in a file, upload to the device and run at any time. The uploading can be
done over LDC, see the Macros section. The following LW3 command is suitable only for running a macro.
Command and Response
ç CALL·/CTRL/MACROS:run(<macro_name>)
æ mO·/CTRL/MACROS:run
Example
ç CALL /CTRL/MACROS:run(Macro1)
æ mO /CTRL/MACROS:run
Values Value description
The rotary direction is clockwise
0
The rotary direction is counterclockwise
1
device. #macro
Applied firmware package: v1.3.0 | LDC software: v2.4.2
MMX8x4-HT series – User's Manual
8.4.10. Control Lock
Enable/disable the operation of the jog dial control knob.
Command and Response
SET·/MANAGEMENT/UI.ControlLock=<control_state>
ç
pw·/MANAGEMENT/UI.ControlLock=<control_state>
æ
Parameters
Parameter Parameter description Values
<control_state> Locking state
Example
ç SET /MANAGEMENT/UI.ControlLock=1
æ pw /MANAGEMENT/UI.ControlLock=1
8.4.11. Resetting the Matrix
The matrix can be restarted – the current connections (LAN, RS-232) will be terminated.
Command and Response #reset
ç CALL·/SYS:reset()
æ mO·/SYS:reset=
Example
ç CALL /SYS:reset()
æ mO /SYS:reset=
8.4.12. Restore the Factory Default Settings
Command and Response #factorydefault
ç CALL·/SYS:factoryDefaults()
æ mO·/SYS:factoryDefaults=
Example
ç CALL /SYS:factoryDefaults()
æ mO /SYS:factoryDefaults=
The device is restarted, current connections are terminated, and the default settings are restored. See the
complete list in Factory Default Settings

#controllock

Value description
The jog dial knob is unlocked
0
The jog dial knob (and the buttons) are locked. In
1
MMX8x8-HDMI-4K-A model, locked status can be
changed with LW3 protocol command or by pressing
Control Lock button for three seconds.
Force locked: the jog dial knob (and the buttons) are
2
locked and they can be unlocked only by LW3 command.
section.
109