Health Menu; Presets Menu - Lightware MX2-8x8-HDMI20-L User Manual


  
4. Operation
Save Submenu
The EDID of a connected sink
can be saved to the User EDID
memory as follows:
Step 1. Navigate to the EDID/
Save submenu.
Step 2. Select the Name item
and press the knob. Use
the jog dial to select the
desired EDID (D1-D8)
and press the knob.
Step 3. Select the Destination item and press the knob. Use the jog dial
to select the desired EDID memory (U1-U100) and press the
knob.
Step 4. Navigate to the Save option and press the knob.
4.3.5. Health Menu
The following information is
displayed about the matrix in this
menu:
▪ Uptime: the elapsed time
since the last booting.
Internal
▪ Control Panel:
Voltage and temperature
values about the front
panel board.
Motherboard: Internal Voltage and temperature values about the
▪
motherboard.
▪ IO ports: Internal Voltage and temperature values about the
Input/Output ports.
4.3.6. Presets Menu
SAVE
Name D1
Preferred Res. 1920x1080p60.00Hz
Monitor Name GW2470
Audio Info 2chLPCM
Destination U1
•
« Save
Back

Load a Preset
CONTROL PANEL
5V 5.18
1.8V 1.82
Temp°C 31.18
Save a Preset
« Back
MX2-HDMI20 series – User's Manual
The router can store presets and
SAVE PRESET
the followings are stored in each
Button4
slot: Input/output crosspoint state,
Button5
muted/unmuted states.
Button6
ATTENTION! When factory
Button7
default settings are restored,
Button8
presets are deleted.
My_pres
«
Back
ATTENTION! The Preset loading has an effect on all ports, except
the locked ones.
Step 1. Navigate to the Presets / Load Preset submenu and press the
knob.
Step 2. The previously save presets are listed. Button1..8 mean the
presets which are also available by the front panel Source
buttons. Select the desired memory slot and press the knob. If
any other preset had been saved previously they would be also
listed.
Step 3. Confirm your selection by pressing the Yes.
INFO: Eight memory slots are available by the front panel buttons,
see Save or Load a Preset section.
Step 1. Create the desired I/O layout.
Step 2. Navigate to the Presets / Save Preset submenu and press the
knob.
Step 3. Select the desired memory slot (Button1..Button8 mean the eight
Source buttons) and press the knob. If any other preset had been
saved previously they would be also listed. See the corresponding
Presets section.
Step 4. Confirm your selection by pressing the Yes.
4
5
6
7
8
25