Table of Contents
Advertisement
3. Front Panel Control
Switch Submenu
#edid
The submenu looks similar to the View submenu, but in this case the
Destination is also listed. To change an EDID, do the following:
Step 1. Navigate to the EDID/Switch submenu.
Step 2. Select the Name item and press the knob. Use the jog dial
to select the desired EDID (F1-F144, U1-U100, or D1-D8) and
press the knob.
Step 3. Select the Destination item and press the knob. Use the jog dial
to select the desired EDID memory (E1-E8, All) and press the
knob.
Step 4. Navigate to the Switch option and press the knob.
Save Submenu
#edid
The EDID of a connected sink can be saved to the User EDID memory
as follows:
Step 1. Navigate to the EDID/Save submenu.
Step 2. Select the Name item and press the knob. Use the jog dial to
select the desired EDID (D1-D8) and press the knob.
Step 3. Select the Destination item and press the knob. Use the jog dial
to select the desired EDID memory (U1-U100) and press the
knob.
Step 4. Navigate to the Save option and press the knob.
3.2.5. Health Menu
The following information is displayed about the matrix in this menu:
Uptime: the elapsed time since the last booting.
▪
▪
Control Panel: Internal Voltage and temperature values about
the front panel board.
▪
Motherboard: Internal Voltage and temperature values about
the motherboard.
▪
IO ports: Internal Voltage and temperature values about the
Input/Output ports.
MX2 Standalone Matrix Switcher series – User's Manual
3.2.6. Presets Menu
The router can store presets, and the following are stored in each slot:
Input/output crosspoint state, muted/unmuted states.
ATTENTION!
deleted.
Load a Preset
ATTENTION!
locked ones.
Step 1. Navigate to the Presets / Load Preset submenu and press the knob.
Step 2. The previously saved presets are listed. Button1..8 mean the presets, which are also available by the
Step 3. Confirm your selection by pressing the Yes.
INFO:
Save a Preset
Step 1. Create the desired I/O layout.
Step 2. Navigate to the Presets / Save Preset submenu and press the knob.
Step 3. Select the desired memory slot (Button1..Button8 mean the eight Source buttons) and press the knob. If any
Step 4. Confirm your selection by pressing Yes.
Applied firmware package: v1.9.0 | LDC software: v2.6.2b3
When factory default settings are restored, presets are
#preset
The Preset loading has an effect on all ports, except the
front panel Source buttons. Select the desired memory slot and press the knob. If any other preset had
been saved previously, they would be also listed.
Eight memory slots are available by the front panel buttons, see the
other preset had been saved previously, they would be also listed. See the corresponding
29
Save or Load a Preset
section.
Presets
section.
Advertisement
Table of Contents
Troubleshooting
