Cec Tool - Lightware MMX8x4-HT420M User Manual

   
6. Software Control – Lightware Device Controller
6.6. CEC Tool
The MMX8x4-HT series matrix switchers are able to send and receive Consumer Electronics Control
(CEC) commands. This feature is for remote control of the source or sink device. CEC is a bi-directional
communication via HDMI cable, in this case between the output port of the matrix switcher and the sink.
Layout of CEC panel in Lightware Device Contoller
#cec
6
MMX8x4-HT series – User's Manual
1
2
1
3
2
4
3
4
5
5
6
It can occur that the third-party device can receive, but not execute the command because it is not supported
by the product. Check the accepted commands in the documentation of the device.

INFO:
address. In this case that is always 40.

ATTENTION!
Applied firmware package: v1.3.0 | LDC software: v2.4.2
Drop-down This list contains the basic CEC commands, most of them are displayed on the
command list graphical interface, too (on the left side). Click on the Send button to execute sending
the command.
Custom The text field is for sending hexadecimal commands to the source. The maximum
command length of the message could be 30 characters (15 bytes). Click on the Send button
textbox to execute sending the command.
OSD string A max. 14 character-long text can be shown on the sink device. The send OSD
textbox (On-screen display) command textbox is the input field of the string. Alphanumeric
characters, glyphs and space are accepted. Click on the Send button to execute the
command.
Received Displays all the sent (in red) CEC commands and the received answers (in blue)
Command box with a timestamp.
Legend of the received message:
< [10:33:17] ACK
Answer for the acknowledged command.
< [10:35:01] NACK
Answer for the not acknowledged command.
< [10:33:17] IN PROGRESS
The command is in progress at the moment.
< [10:33:17] FAILED
Answer for other failure.
< [10:35:40] feature_abort_<*>
This is the most common answer from the third-party devices when the command
is delivered, but the execution is refused. The cause of the refuse stands after
'feature_abort' expression.
Clear button Click on the Clear button to erase the content of the terminal window.
CEC command This panel provides the quick and easy management of CEC commands. These
button panel buttons are pre-programmed with basic functions and sends commands towards
the sink. The communication is displayed in the Received Command box. For the
list of the commands see the CEC Command Sending
functionality are similar to the design of a remote control.
The first 2x2 bit of the CEC commands contains identification data of the source and destination
Make sure that the controlled unit is CEC-capable and this function is enabled.
61
section. Both the layout and