Health Menu; Presets Menu - Lightware MX2-4x4-HDMI20-CA User Manual


  
4. Front Panel Control
Switch Submenu #edid
The submenu looks similar as the View submenu but in this case, the
Destination is also listed. To change an EDID do the followings:
Step 1. Navigate to the EDID/Switch submenu.
Step 2. Select the Name item and press the knob. Use the jog dial
to select the desired EDID (F1-F144, U1-U100, or D1-D8) and
press the knob.
Step 3. Select the Destination item and press the knob. Use the jog dial
to select the desired EDID memory (E1-E8, All) and press the
knob.
Step 4. Navigate to the Switch option and press the knob.
Save Submenu #edid
The EDID of a connected sink can be saved to the User EDID memory
as follows:
Step 1. Navigate to the EDID/Save submenu.
Step 2. Select the Name item and press the knob. Use the jog dial to
select the desired EDID (D1-D8) and press the knob.
Step 3. Select the Destination item and press the knob. Use the jog dial
to select the desired EDID memory (U1-U100) and press the
knob.
Step 4. Navigate to the Save option and press the knob.
3.2.5. Health Menu
The following information is displayed about the matrix in this menu:
Uptime: the elapsed time since the last booting.
▪
Control Panel: Internal Voltage and temperature values about
▪
the front panel board.
▪ Motherboard: Internal Voltage and temperature values about
the motherboard.
▪ IO ports: Internal Voltage and temperature values about the
Input/Output ports.
MX2-HDMI20 series – User's Manual
3.2.6. Presets Menu
The router can store presets and the followings are stored in each slot:
Input/output crosspoint state, muted/unmuted states.
ATTENTION! When factory default settings are restored, presets are
deleted.
Load a Preset
ATTENTION! The Preset loading has an effect on all ports, except the
locked ones.
Step 1. Navigate to the Presets / Load Preset submenu and press the knob.
Step 2. The previously save presets are listed. Button1..8 mean the presets which are also available by the
Step 3. Confirm your selection by pressing the Yes.
INFO: Eight memory slots are available by the front panel buttons, see
Save a Preset
Step 1. Create the desired I/O layout.
Step 2. Navigate to the Presets / Save Preset submenu and press the knob.
Step 3. Select the desired memory slot (Button1..Button8 mean the eight Source buttons) and press the knob. If any
Step 4. Confirm your selection by pressing the Yes.
Applied firmware package: v1.7.0 | LDC software: v2.5.1b5
#preset
front panel Source buttons. Select the desired memory slot and press the knob. If any other preset had
been saved previously they would be also listed.
other preset had been saved previously they would be also listed. See the corresponding
28
Save or Load a Preset section.
Presets section.