Table of Contents
Advertisement
When the station is connected to the controller PC through the RS232 or
3.8 Direct readings
USB cable, the Direct Readings button is used to open a window where it
is possible to immediately read the basic station data.
With this function the User can read the field values acquired by the station
without post-processing them; that is, without any RMS or arithmetic
average, or maximum. The data, which can be requested at any time, are
updated by the station 20 times per minute (every 3 seconds) so a higher
reading frequency will produce only redundant data.
The "Get" button is used to request the field value of different frequency
bands (depending on the antenna), battery voltage and temperature.
To request the values automatically every nn seconds, set the value nn
indicated in Get every and enable √ Auto Repeat option. The "Get" button
is disable.
The "Log Data" command allows to record the set of values read in a text
file, in order to save the data to process them, if necessary, at a later time.
To start the save, press the Log Data button.
Press again to stop saving.
The actual status is shown in the window at the bottom (Getting Data)
3-24
8061SW-02 - User's guide and Data Display
Advertisement
Table of Contents
