Table of Contents
Advertisement
Command
SBND n,
start,stop
SCLD
SCLT
SCNL
SDIC
5-16
SMS Messages and Commands
Description
Specified band frequency setting
Format: SBND n,start,stop
Where:
n is the band index, between 1 and 20
Start and Stop are the corresponding
frequencies, expressed in MHz.
It is mandatory that Start is lower than
Stop.
It is not recommended to set a Start
frequency lower than another one
before, in order not to waste time.
Set Start = 0 to cancel a band
The reply is:
BND=OK if command granted
BND=ERR when there are errors and
the command is rejected
BND=VOID when the band has been
deleted.
Clock date setting.
Format: SCLD DD.MM.YY
The response is the same as in the
?CLK command.
Clock time setting.
Format: SCLT HH.MM.SS
The response is the same as in the
?CLK command.
The SCLT command should not be sent
by SMS as, being the message delivery
time not known, the station clock would
not be set as expected. See the SSTS
command for clock setting by SMS."
This command enable a deferred call to
the number nnnnnnnn
The call is initiated d minutes later.
The format is:
#SMSCNL d nnnnnnnn *
where d is in minutes between 1 and 9
and nnnnnnnn is the remote phone
number to be called.
This command disables the station's
outgoing calls.
When disabled the MODEM will power
on at time set with the STMS and enters
a stand by state, ready for incoming
calls or SMS messages.
(same response as ?TSM command).
Example
Example: #SMSBND 1,21,80*
Response: BND=OK
The first band (#1) is set starting at 21
MHz and ending at 80 MHz
Example: #SMSCLD 12.08.15*
Response:CLK=11.55.57;12.08.15
Example: #SMSCLT 12.13.40*
Response:CLK=12.13.40;12.08.15
Example: #SMSCNL 5 5550101*
Response: CNL=5550101
The station will call that phone number
after 5 minutes.
Example: #SMSDIC*
Response:
TSM=OFF 14:53 ( 1q) each 24h
Confirm the station is disabled to call.
The modem scheduling is showed too.
Advertisement
Table of Contents
