Table of Contents
Advertisement
3.4.2.1 Changing the
SETTING password
3-12
8061SW-02 - User's guide and Data Display
Every time you have to modify a field, the Setting Password will be
requested by the software. At the beginning, for the first setting
operations, it would be helpful to leave these password blank, simply
pressing enter on the keyboard.
Set a password only after all your area monitors will be correctly set,
and just in case you need to have an higher security level.
The User can enter any sequence of alphanumerical characters; any
special characters are not allowed.
Always take note of the Setting Password entered.
If it is necessary to change the Setting Password, just press function
key F10 while the software is displaying the station setting window.
The software displays the message:
If a wrong Setting Password is entered, the following message pops up::
If the answer is YES, first enter the old
Setting Password, then enter the new
one.
Press OK and try again.
Advertisement
Table of Contents
