Table of Contents
Advertisement
5.6.9 Checksum
As previously mentioned, there is a little endian 16 bit unsigned int which is
called checksum. The checksum is intended for verifying the reliability of
algorithm
the array read mainly from the AMS-8061's side as a corrupt configuration
could potentially make the AMS-8061 ineffectual.
Therefore the application must ensure that the checksum in the 8061.CFG
file reflects the actual state of the configuration setting. Otherwise, if the
checksum does not match the exact value, the new configuration will be
ignored.
The Checksum is calculated as the sum of all the bytes involved starting
from a seed of 0xAAAA.
Then, from the result the modulo 0x10000 is taken (which also means
truncating the result to 4 bytes).
5-34
SMS Messages and Commands
Advertisement
Table of Contents
