Table of Contents
Advertisement
Command
Description
Reset to both default configuration and
SRSTR
storing rate.
Similar to SRST command, in addition to
its default settings, resets also the storing
rate to 6 minutes.
Pay attention this command invalidates any
data already stored in the Station.
The reply is RST RATE=OK
Modem phone number setting.
STDM
In the following format:
#SMSTDMn xxxxxxxxxx*
where: n is the list # between 0 and 9,
xxxxxxxxxx is the phone #.
To replace simply rewrite the number, to
cancel write down 00000.
(same response as ?TDMn command).
SMS phone number setting.
STDS
In the following format:
#SMSTDSn xxxxxxxxxx*
where: n is the list # between 0 and 9,
xxxxxxxxxx is the phone #.
To replace simply rewrite the number, to
cancel write down 00000.
(same response as ?TDSn command).
Ethernet programmed time setting.
STSE
In the following format:
#SMSTSE HH.mm.xx.ee*
where: HH.mm is the Ethernet port power
on time.
xx on time period (must be 01 fixed, which
means 10 minutes).
To save energy it is recommended to
switch the LAN port off as soon as it is not
needed anymore, via the SETH command.
ee repetition interval in hours (the value
can be 12 or 24).
Example
Example: #SMSRSTR*
Response: RST RATE=OK
confirming the command has been
granted.
Example: #SMSTDM2 987654321*
Response: TDM2=987654321
Example: #SMSTDS2 0000000*
Response:TDS2=VOID*
Example: #SMSTSE 12.10.01.24*
Response:
TSE=ON 12:10 each 24h
the Ethernet port will power everyday
on at 12:10, and will stay ready for 10
minutes.
SMS Messages and Commands
5-21
Advertisement
Table of Contents
