Table of Contents
Advertisement
Command
Description
This command enables immediately the
SGOIF
GPS module.
It remains on until the firs FIX or the
timeout (4 minutes), then it will send a
feedback SMS to all the saved phone
numbers (SMS list) in NMEA RMC format
(NMEA 0183 ver 3.01).
The reply is GOI Feedback=OK.
Shows (0) or hide (1) the User, Password
SHFTP
and IP Address (FTP mode) on the RS232
port sniffer.
0: User, Password e IP address are shown
on RS232 sniffer.
1: User, Password e IP address are hidden
on RS232 sniffer.
In FTP communication mode the command
and feedback are replaced by "@@@".
This status also affects ?GPR3, ?GPR4,
?GPR5, ?GPR7 and ?GPRA commands.
Station identifier setting.
SIDN
Max 20 characters.
The response is the same as for the ?IDN
command.
The command format is:
#SMSIDN Station Name*
The use of this command via SMS, while
properly setting the new identifier, could not
get an answer. This happens if the length
of the response message, including the
response to the command recognition
password, exceeds the maximum number
of characters allowed for SMS.
Example
Example: #SMSGOIF*
Response:
GOI Feedback=OK
confirming the command has been
granted.
Example: #SMSHFTP0*
Response: #SM OK*
confirming the command has been
granted.
Example: #SMSHFTP1*
Response: #SM OK*
confirming the command has been
granted.
Example: #SM SIDN Marconi Inst. 23*
Response:
IDN=Marconi Inst. 23;Nsts,AMS-8061;
A.43 08/15;000WX50803;
13/08/2015;OFF 12:05 ( 4q) each
01h;OFF 16:00 ( 2q) each 24h;--L------
---;
SMS Messages and Commands
5-19
Advertisement
Table of Contents
