Table of Contents
Advertisement
23) Before installing the triaxial antenna, make sure the monitoring station
is switched off. Carefully connect the antenna output to the receiver RF
input and plug the antenna data connector looking at the alignment of the
two red spot on the data connectors.
To remove the antenna, extract the multipolar connector first holding
it by the metallic part, then turn the RF connector ring nut.
Do not insert or remove the antenna holding it by the head or by the
data cable as serious damage may occur.
The AMS-8061 station cannot operate without antenna even when
downloading acquired field data.
In case the antenna is accidentally removed when station is ON a
reset will be required: switch the station OFF, connect the triaxial
antenna and switch ON again.
2-16
Installation and use
Advertisement
Table of Contents
