Table of Contents
Advertisement
Command
Description
This command disables the Ethernet port
SDIE
planned activity.
If disabled, the LAN port stays permanently
off independently from the time schedule
set via the STSE command.
(same response as ?TSE command).
This command disables the GPS module.
SDIG
If disabled, the GPS stays permanently off
to save energy.
(same response as ?TSG command).
SMS Report send disabling.
SDIR
When disabled the GSM modem will power
on at time set with the STMS command
and enter a stand by state, ready for
incoming call or SMS messages.
(same response as ?TSS command).
Modem disabling command.
SDMO
This is accepted only in case of Battery
Alarm (low voltage).
When disabled the GSM modem will power
off, until the battery alarm ends.
(same response as ?TSM command).
This command enables the station to call.
SENC
The time of call shall be set with STSM
command.
The station power on the MODEM, initiate
the communication link and call the first
number in the MODEM phone number list,
at the end of call the modem enter a stand
by state for the time remaining.
Note that only call is enabled and not also
the modem power on.
(same response as ?TSM command).
This command enables the Ethernet port to
SENE
switch on at the planned time.
The time of call shall be set with STSE
command.
The station power on the LAN port and it
remains on for 10 minutes.
(same response as ?TSE command).
Example
Example: #SMSDIE*
Response:
TSE=OFF 12:00 each 24h
confirming the LAN port is disabled
(OFF).
Example: #SMSDIG*
Response:
TSG=OFF 12:00 each 24h
confirming the GPS is disabled (OFF).
Example: #SMSDIR*
Response:
TSS=OFF 16:15 ( 2q) each 24h
Confirm the station is disabled to send
SMS report. The "schedule for SMS" is
showed too.
Example: #SMSDMO*
Response:
TSM=16:15 ( 1q) each 24h
The (DIS) string is not shown at the end
of the reply, it means the disabling
command has been ignored.
Example: #SMSENC*
Response:
TSM=ON 14:53 ( 1q) each 24h
Confirm the station is enabled (ON) to
call. The "schedule for modem" is
showed too.
Example: #SMSENE*
Response:
TSE=ON 12:00 each 24h
Confirm the LAN port is enabled (ON) to
be ready at the programmed time.
SMS Messages and Commands
5-17
Advertisement
Table of Contents
