Table of Contents
Advertisement
Command
Description
SMS Report send enabling.
SENR
When enabled the station power on the
GSM, at the time set with the STSS
command, initializes communication and
send the report with a SMS message to all
phones in the SMS numbers list, at the end
it enter the stand by state for the time
remaining.
Note that only message sending is enabled
and not also the GSM power on.
(same response as ?TSS command).
This command hangs up the Ethernet
SETH
communication and switches the LAN port
OFF.
It is recommended to switch the Ethernet
port OFF as soon as it becomes no more
necessary.
The reply is ETH=OK
Set internal clock updating mode:
SGCS
Set the internal clock in manual mode
sending #SMSGCSM* command; change
time and date by SCLT and SCLD
command.
Set the internal clock by GPS sending the
#SMSGCSAx* command (x represents the
time zone and the value must be between -
12 and 12 hours).
The automatic internal clock updating
depends on the GPS strength; in case of
success all events available are updated
with
dd/mm/hh".
This command enables immediately the
SGOI
GPS module.
It remains on until the first FIX or the
timeout (4 minutes).
The reply is GOI=OK.
5-18
SMS Messages and Commands
the
string
"Auto
Example
Example: #SMSENR*
Response:
TSS=ON 12:00 ( 2q) each 24h
Confirm the station is enabled to send
SMS report. The "schedule for SMS" is
showed too.
Example: #SMSETH*
Response: ETH=OK
confirming the command has been
granted.
Example: #SMSGCSM*
Response: #SM OK*
confirming the command has been
granted.
Example: #SMSGCSA2*
Response: #SM OK*
confirming the command has been
granted.
Otherwise with #SM GCS ERROR* and
turns the internal clock in manual mode.
Set:hh:mm:ss;
Example: #SMSGOI*
Response:
GOI=OK
confirming the command has been
granted.
Advertisement
Table of Contents
