Installation; Through Wall Installation; Top Wall Installation - ProMinent DULCOMETER PH-501 Assembly And Operating Instructions Manual

INSTALLATION

Step Five
Through Wall Installation: Flowline's Switch Tek™
level switches may be installed through the top, side
or bottom of a tank wall. The sensor has male 3/4"
NPT threads on either side of a 15/16" wrench flat.
This enables the user to select the sensor's mounting
orientation, installed outside of the tank in, or inside
of the tank out.
Always install the 3/4" Viton gasket with the metric (long sensor length) versions of the L_ _ _ _ _2_.
The G threaded version of the Switch Tek™ will not seal unless the gasket is installed properly.
Top Wall Installation: The powered level switches may be installed through the top wall of a tank. Flowline's
Smart Trak LM10 series mounting system is an in tank fitting which enables users to install up to four
FLOWLINE sensors of any technology, to any depth, along the entire length of track. Smart Trak may be
installed through the top wall of any tank using a standard 2" NPT tank adapter. If no tank top installation is
available, Flowline's side mount bracket, LM50 1001, enables Smart Trak to be installed directly to the side
wall of a tank. Do not use PFA Teflon sensors with Smart Trak.
Flowline's Switch Pak LM45 series mounting system is an in tank fitting which enables users to install one
FLOWLINE sensor, of any technology, to a specific depth. The Flowline sensor may be installed onto the 3/4"
NPT adapter at the end of the Switch Pak. Switch Pak may be installed through the top wall of any tank using a
standard 2" NPT tank adapter. Flowline's side mount bracket, model LM50 1001, may also be used if top wall
installation is not available.
Rev A LO900002 11 of 20
E-1267