Parameter Setting; General Parameter Setting - ProMinent DULCOMETER PH-501 Assembly And Operating Instructions Manual

9 Parameter setting

During parameter setting the unit remains in the operating mode. It continues its
monitoring function with the existing parameters until the parameter setting has
been completed.
immediately.

9.1 General parameter setting

3 steps must be taken for each parameter setting:
1 Select parameter
Touch [Mode/Enter] until the re-
quested parameter is displayed.
2 Set parameter value
Touch [Set] and keep it touched.
> Current setting value of the param-
eter flashes for 5 s.
> After 5 s: setting value is changed:
step by step by touching briefly
several times or continuously by
touching permanently.
Numerical values are incremented continuously. To reduce the value: let the display
move to the maximum setting value. Then the cycle starts again at the minimum
setting value.
3 Acknowledge parameter value
Touch [Mode/Enter] briefly.
> The parameter is displayed again.
The new setting value is saved.
Set other parameters
Start again with step 1.
Finish parameter setting
Touch [Mode/Enter] several times until the current measured value is displayed or wait
for 15 s.
> The unit returns to the operating mode.
Timeout:
If no touch button is activated for 15 s during parameter setting, the unit returns to the
operating mode with unchanged values.
16
Mode/ Set
Enter
Mode/ Set
Enter
Mode/ Set
Enter
E-1390