ProMinent DULCOMETER PH-501 Assembly And Operating Instructions Manual page 804

For the tightening torques for terminal board
connections (except terminal strips), see
Chapter 3.1, "Mechanical data",
Section "Tightening torques for screw
connections", Pg. 10.
For terminals with clamping straps (e.g. as per
DIN 46282), the conductors must be inserted
so that approximately the same clamping
height results on both sides of the bar.
Individual conductors must therefore be bent
into a U-shape or connected with a cable lug
(DIN 46234).
This also applies to:
the protective conductor,
the outer ground conductor.
Both conductors can be recognized from their
color (green/yellow).
© Gardner Denver Deutschland GmbH 17 / 28
Installation
610.44436.40.000