Hmi Alarm Screen - ProMinent DULCOMETER PH-501 Assembly And Operating Instructions Manual

5.1.5 HMI Alarm Screen

When the ALARMS
Press the ALARMS
To clear alarms, first press the yellow RESET button then press the flashing ALARMS
button to verify that the condition causing the alarm has been cleared.
All alarms are visually indicated on a beacon stack on the roof of the exterior of the container
and an alarm light on the system control panel:
Green – System OK
Red Solid – Warning Alarm
Red Flashing – Critical Alarm
No Light – Loss of Power
newterra O&M Manual
© 2017 by newterra, ltd.
All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means, electronic, mechanical,
photocopying, recording, or otherwise, without prior written permission of newterra ltd.
button is flashing red, it indicates an alarm is present in the system.
button to be routed to the Active Alarms Screen.
1291 California Avenue, Brockville, ON K6V 5W3
(800) 420-4056 / www.newterra.com
newterra ltd.
41