8.4 Explanation of the menu level 2
Uni
Standard unit of measurement for system pressure (bar or PSI).
Display mode:
SELd
Pressure in the unit set in [Uni].
Pressure in % of the set scaling of the analogue output.
ASP
Analogue start point for system pressure: measured value at which 4 mA is
provided (20 mA if [OU2] = [InEG]).
AEP
Analogue end point for system pressure: measured value at which 20 mA is
provided (4 mA if [OU2] = [InEG]).
HI
Maximum value memory for system pressure.
LO
Minimum value memory for system pressure.
COF
Zero-point calibration.
dS1
Switch-on delay for OUT1.
dr1
Switch-off delay for OUT1.
P-n
Switching logic for OUT1: pnp or npn.
dAP
Damping for switching outputs and display.
dAA
Damping for analogue output (OUT2).
diS
Update rate and orientation of the display.
LED
Setting for the LED ring.
CAL
Calibration function (setting the curve of measured values).
CP1
Calibration point 1
CP2
Calibration point 2
rES
Restore factory settings.
UK
E-1389
15