16. Assemble the gear cover (3) and gasket (7) to the gear headplate (18) using socket head screw (5). Tighten
the capscrews alternately and evenly. Refer to FIGURE 7-9 for torque specifications.
17. Place the blower on its feet on a flat surface. Loosen cap screws (16) and level the unit up. The bench or
blower base flatness should be within .002 of an inch. Re-tighten cap screws (16) to the specification in
FIGURE 7-9.
FASTENERS
CAPSCREW (21)
CAPSCREW (16)
SOCKET HD CAPSCREW (5)
SOCKET HD CAPSCREW (30)
CAPSCREW (10)
23 – 30
42 – 45
23 – 30
42 – 45
6 – 8
16 – 18
6 – 8
16 – 18
6 – 8
38 – 42
42 – 45
42 – 45
11 – 13
11 – 13
38 – 42
E-128