ProMinent DULCOMETER PH-501 Assembly And Operating Instructions Manual page 835

Factory genuine parts, manufactured to design tolerances, are developed for optimum dependability - - -
specifically for your blower. Design and material innovations are born from years of experience with hundreds of
different blower applications. When you specify factory genuine parts you are assured of receiving parts that
incorporate the most current design advancements manufactured in our state-of-the-art blower factory under
exacting quality standards.
Your AUTHORIZED DISTRIBUTOR offers all the backup you require. A worldwide network of authorized
distributors provides the finest product support in the blower industry.
1. Trained technical representatives to assist you in selecting the correct replacement parts.
2. Complete inventory of new machines and new, genuine factory parts.
3. A full line of factory tested AEON
performance in all blowers.
4. Authorized distributor service technicians are factory-trained and skilled in blower maintenance and
repair. They are ready to respond and assist you by providing fast, expert maintenance and repair
service.
1. Face the blower drive shaft.
2. In a
3. In a
4. In a vertical configuration, a
center line of the blower. A
of the blower.
5. In a horizontal configuration, a
center line of the blower. A
line of the blower.
For pricing, and ordering information contact your nearest AUTHORIZED FACTORY DISTRIBUTOR. When
ordering parts, specify Blower
Rely upon the knowledge and experience of your AUTHORIZED DISTRIBUTOR and let them assist you in
making the proper parts selection for your blower.
To Contact Gardner Denver or locate your local distributor:
®
PD blower lubricants, specifically formulated for optimum
configuration, air flow is horizontal.
configuration, air flow is vertical.
and
Visit: www.contactgd.com/mobile
Call: (217)222-5400
exists when the drive shaft is below the horizontal
exits when the drive shaft is above the horizontal center line
exists when the drive shaft is to the right of the vertical
exists when the drive shaft is to the left of the vertical center
(see nameplate on unit).
Or
E-92